Then, we cut 3 top and bottom pieces at 81 or 3 less than 7. We cut each side piece for the top at 3 and each side piece for the bottom at 4. Home diy movable partition wall room divider wiht wheels furniture, US 50 - 300 / Square Meter, Screens & Room Dividers, Traditional Chinese, 4.Source from Foshan Sanseng Hardware Co., Ltd. The entire wall would have dimensions of 7 x 7. I left as small a gap between the two back-to-back KALLAX units as possible. For the wall, we knew we wanted the lower portion to be 4 tall and the top portion to be 3 tall. So I cut paint stir-sticks into approximately 5 cm long pieces, drilled a hole through the centre and placed them between the gap to compensate for the height difference.Īfter checking that all positions and levels were right, I screwed the KALLAX units to the top plate. Make two pocket holes in the ends of all the frames’ cross supports and attach them to the side supports using the recommended 2 1/2 inch pocket hole screws. If you are using a Kreg Jig make sure to set your board thickness at 1 1/2 inches. There is a slight height difference between the vertical walls and the top and bottom panels. Step 1) Construct the top and bottom frames. I found it easiest to lay the top plate (white board) on the floor. Then, position the two KALLAX units (back to back) on the top plate.Īfter that, I measured carefully so that the KALLAX units would end up at equal distances from the edge on all sides. Once I completed the drilling, I was ready to attach the top plate (white board). So, I made the hole large enough for a screw head to come through on the inner side. (refer to 2)
The two center holes (pink dots) have more or less no supporting material on the inside. The drawing above shows drill holes for one KALLAX unit